Product ID:SUNPROOF HOUSE PAINT DEEPTONE BASE, 1-200 (
MSDS Date:04/04/1991
FSC:8010
NIIN:00N025484
MSDS Number: BMBMW

Emergency Phone: 304-843-1300

Info Phone: 800-245-2590; 412-492-5555

Cage: 47695

Telephone: 1-800-245-2974 (CAL HYPO)

Cage: 47695

NO INGREDIENT FOR THIS FORMULATION_INGREDIENT

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE:INGEST:HARMFUL/FATAL. EYE:CAUSES
EYE IRRIT. SKIN:MAY CAUSE MODERATE IRRIT. INHAL:VAP & SPRAY MAY BE
HARMFUL. VAP IRRIT EYES/NOSE THROAT. SANDING & GRINDING DUSTS MAY
BE HARMFUL. RPTD EXPOS TO HI GH VAP CONC MAY CAUSE IRRIT OF RESP
SYS& PERM BRAIN & NERVOUS SYS DMG. INTENTIONAL MISUSE BY (EFTS OF
OVEREXPOS)
Explanation of Carcinogenicity:CRYSTALLINE SILICA:IARC GRP 2A.
Effects of Overexposure:HLTH HAZ:DELIBERATELY CONC & INHAL CONTENTS CAN
BE HARMFUL/FATAL. CHRONIC:AVOID LONG TERM & RPTD CONTACT. PROD
CONTAINS TITANIUM DIOXIDE. ANIMALS INHALING MASSIVE AMTS OF
TITANIUM DIOXIDE DUST IN A LO NG-TERM STUDY DEV LUNG TUMORS.
POTENTIAL FOR INHAL OF TITANIUM DIOXIDE DUSTS FROM COATINGS IS VERY
LIM. PROD (SUPDAT)

First Aid:INGEST:DO NOT INDUCE VOMIT. SEE MD. EYE:FLUSH IMMED W/PLENTY
OF WATER FOR AT LEAST 15 MIN. SEE MD IF IRRITATION PERSISTS.
SKIN:REMOVE PROMPTLY BY WIPING, FOLLOWED BY WATERLESS HAND CLEANER
& SOAP & W ATER. IF IRRIT PERSISTS, SEE MD. INHAL:REMOVE TO FRESH
AIR. APPLY ARTIF RESP & OTHER SUPPORTIVE MEASURES AS REQ. IF BRTHG
DIFFICULTY DEVELOPS, SEE MD.

Flash Point Method:PMCC
Flash Point:108F,42C
Lower Limits:1.0%
Extinguishing Media:USE NFPA CLASS B EXTING (CO*2, DRY CHEMICAL,
UNIVERSAL AQUEOUS FILM FOAM) DESIGNED TO EXTING NFPA CLASS II
(SUPDAT)
Fire Fighting Procedures:WATER SPRAY MAY BE INEFT, BUT MAY BE USED TO
COOL CLSD CONTR TO PREV PRESS BUILD-UP & POSS AUTOIGNIT/EXPLOS WHEN
EXPOS TO EXTREME HEAT. IF (SUPDAT)
Unusual Fire/Explosion Hazard:KEEP CONTR TIGHTLY CLSD. ISOLATE FROM
HEAT, ELECT, SPARKS & OPEN FLAMES. CLSD CONTR MAY EXPLODE WHEN
EXPOSED TO EXTREME HEAT. DO NOT APPLY ON HOT SURF. (SUPDAT)

Spill Release Procedures:PROVIDE MAX VENT. ONLY PERSONNEL EQUIPPED
W/PROPER RESP & SKIN & EYE PROT SHOULD BE PERMITTED IN AREA. REMOVE
ALL SOURCES OF IGNITION. TAKE UP SPILLED MATL W/SAWDUST,
VERMICULITE/OTHER ABSORB MATL & P LACE INTO CONTR FOR DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LRG
AMTS IN BLDG DESIGNED & PROTECTED FOR STORAGE OF NFPA CLASS II
COMBUST LIQ.
Other Precautions:IF MATERIAL IS PART OF A MULTIPLE COMPONENT COATING
SYS, READ MSDS FOR OTHER COMPONENT(S) BEFORE BLENDING AS RSLTG MIX
MAY HAVE HAZS OF ALL PARTS. AVOID FREE FALL OF LIQ IN EXCESS OF A
FEW INCHES. CON TRS SHOULD BE GROUNDED WHEN POURING.

Respiratory Protection:VENT CONTROLS, VAP EXHAUST, FRESH AIR
ENTRY/NIOSH/MSHA APPRVD (TC-23C) PAINT SPRAY/AIR SUPPLIED (TC-19C)
RESP. READ RESP MFR'S INSTRUC/LIT CAREFULLY TO DETERM TYPE OF
AIRBORNE CONTAM AGAINST WHICH RES P IS EFT & HOW IT IS TO BE PROP
FITTED.
Ventilation:PROVIDE GENERAL DILUTION/LOC EXHAUST VENT IN VOL & PATTERN
TO KEEP CONC OF INGRED BELOW LOWEST SUGGESTED EXPOS (ING 12)
Protective Gloves:IMPERV SUCH AS NEOPRENE, NITRILE, LATEX.
Eye Protection:CHEM WORK GOGG/FULL LENGTH FCSHLD.
Other Protective Equipment:PROT CLTHG, INCLUDING IMPERVIOUS APRON OF
POLYVINYL ALCOHOL, NEOPRENE RUBBER OR NITRILE RUBBER.
Work Hygienic Practices:CLEAN OR DISCARD CONTAMINATED CLOTHING AND
SHOES.
Supplemental Safety and Health
EXT MEDIA:COMBUST LIQ FIRES. FIRE FIGHT PROC:H*2O IS USED, FOG NOZZ ARE
PREF. WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP . EXPLOS
HAZ:TOX GASES MAY FORM WHEN PROD IS CONTACTED BY FLAME/HOT SU RF.
EFTS OF OVEREXPOS:CONTAINS A FORM OF CRYSTALLINE SILICA WHICH IARC
ASSOC W/ (ING 7)

Boiling Pt:B.P. Text:>280F,>138C
Vapor Pres:2.1
Vapor Density:HVR/AIR
Spec Gravity:1.12
Evaporation Rate & Reference:18 (BU AC = 100)
Solubility in Water:0.2%
Appearance and Odor:VISCOUS LIQUID W/AN ODOR CHARACTERISTIC OF SOLVENTS
LISTED IN INGRED SECTION.
Percent Volatiles by Volume:45.10

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS OR STRONG
OXIDIZING AGENTS
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRODUCE HAZ DECOMP PROD WHEN
HEATED. WELDING, BRAZING/FLAME-CUTTING. MAY PRODUCE FUMES
INCLUDING:CO.

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE
WITH FEDERAL, STATE, PROVINCIAL AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THROUGH AN APPROVED WAS TE MANAGEMENT FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.